Easiest Sourdough Bread

Ingredients For Starter:

Note: Once your starter is established, use it to make my sourdough bread.

  • 1x (5lb) bag all purpose flour (I use either KAF, Trader Joe’s, or Whole Foods)
  • 1/2 cup (60g) whole wheat flour (I use KAF whole wheat)
  • Water (preferably warm around 85F )

TIPS:

  • The overall process typically takes 7 days, if the temperature is warm enough. However, it can take up to 2 weeks or more for a strong starter to become established. Please be patient. Find a warm spot for your starter to rise (see tip in recipe below), and use warm water in your feedings (if necessary) to give the fermentation a boost.
  • Only a small amount of whole wheat flour is used to jumpstart the fermentation process. If you don’t want to commit to a large bag, smaller bags are available in most grocery stores. Alternatively, you can use all purpose flour only.
  • You will also need one large 3/4 L jar, or something of similar size (I use this one.).




Instructions

Day 1: Combine 60 g (1⁄2 cup) of whole wheat flour and 60 g (1⁄4 cup) of warm water in a large jar. Mix with a fork until smooth; the consistency will be thick and pasty. If measuring by volume, add more water to slightly thin out the texture if necessary. Cover with plastic wrap, reusable wax wrap, or a lid and let it rest in a warm spot, about 75-80 F, for 24 hours. Temperature is important.

TIP: Looking for a warm spot? Place your starter on a cookie sheet inside the oven (turned off) with the light on for an hour or two (it can get hot in there, so keep you eye on it!). Center rack is best. You can also use a proofing box set to your desired temperature, or a microwave with the door ajar and light on.

Day 2: Check to see if any bubbles have appeared on the surface. If you don’t see anything, it’s okay. The bubbles might have appeared and dissolved overnight while you were sleeping. You don’t have to do anything else now. Rest the starter for another 24 hours.

TIP: During the creation process, and even after your starter has been established, a dark liquid might appear on the surface and throughout the culture. It has a very stinky smell, similar to rubbing alcohol or gym socks. This liquid is called “hooch” and is an indication that your starter needs to be fed. It’s normal. Any time you see this liquid, it’s best to remove it along with any discolored starter present. However, on Day 2 just leave the hooch alone. You can remove it tomorrow when you start the feedings.

Day 3: Remove and discard approximately half of your starter from the jar (you should have 60 g left). The texture will be very stretchy. Add 60 g (1⁄2 cup) of all-purpose flour and 60 g (1/4 cup) of warm water to the jar. Mix with a fork until smooth. The texture should resemble thick pancake batter or plain yogurt at this point. Cover and let rest in your warm spot for another 24 hours.

Days 4, 5 & 6: Continue feeding your starter: remove and discard about half and add 60 g flour + 60 g warm water each day.

As the yeast begins to develop, your starter will rise, and bubbles will form on the surface and throughout the culture. When the starter falls, it’s time to feed it again. TIP: Place a rubber band or piece of masking tape around the jar to measure the starter’s growth as it rises.

Day 7: By now, your starter should have doubled in size. You should see plenty of bubbles, both large and small. The texture will be spongy, fluffy, and similar to roasted marshmallows (think: s’mores). It should smell pleasant, and not link stinky like gym socks. If these conditions are met, your starter is now active and ready to use!
Please keep in mind, if your starter is not ready at this point which is quite common due to temperature issues (too cold), timing, and other factors, continue the feeding it for 1-2 weeks or more. Be patient!
The very last step is to transfer your starter to a nice, clean jar. In keeping with tradition, you can also name it and please do! My starter is called Dillon, after my oldest boy.


At a glance, your overall daily schedule with measurements should look like this:

  • Day 1: 60 g flour + 60 g water = 120 g starter
  • Day 2: Do nothing
  • Day 3: Remove & discard half of the starter/ 60 g starter + 60 g flour + 60 g water = 180 g starter
  • Day 4: Remove & discard half of the starter/ 90 g starter + 60 g flour + 60 g water = 210 g starter
  • Day 5: Remove & discard half of the starter/ 105 g starter + 60 g flour + 60 g water = 225 g starter
  • Day 6: Remove & discard half of the starter/ 112.2 g starter + 60 g flour + 60 g water = 232.5 g starter
  • Day 7: Remove & discard half of the starter/ 116.25 g starter + 60 g flour + 60 g water = 236.27 g starter

Ingredients:

  • 1 cup sourdough starter
  • 2 cups all-purpose flour
  • 1 teaspoon salt
  • 1 cup water

 

Instructions:

  1. Mix together the sourdough starter, flour, salt, and water in a large bowl until a dough forms.
  2. Knead the dough on a floured surface for 5-10 minutes.
  3. Place the dough in a greased bowl, cover, and let it rise for 8-12 hours.
  4. Preheat oven to 450°F (230°C). Place a Dutch oven or lidded casserole dish in the oven as it preheats.
  5. Once the oven is hot, carefully remove the dish and place the dough inside.
  6. Cover with the lid and bake for 30 minutes.
  7. Remove the lid and bake for an additional 15-20 minutes until the crust is golden brown.
  8. Remove the bread from the oven and let it cool on a wire rack.

Enjoy your homemade sourdough bread!



Article Categories:
All Recipes

Comments

  • what is sourdough starter please and would supermarkets sell this thanks

    Yvonne Lonie January 30, 2023 10:17 am Reply
  • Recipe for sourdough stater

    Betty January 31, 2023 5:54 pm Reply

Leave a Reply

Your email address will not be published. Required fields are marked *

Don't Miss! random posts ..